Temporary Power in Corte Madera
Generators, cameras and cooling for Corte Madera retail, office and residential jobs on low, flat ground by the bay.
Flat ground, wet winters: Corte Madera jobs
Much of Corte Madera east of 101 sits close to sea level near the marsh. That makes winter storms and high tides a real concern for any site equipment. We check the flood map for the parcel and set the pole, panel and generator on the highest practical ground, with cords hung off the slab. A pole set in a low corner can sit in water for days after a big storm.
The work mix here leans toward retail and office tenant improvements, plus home remodels in the older neighborhoods on both sides of the freeway. Retail jobs often run on tight hours to avoid shoppers, and a temp service may need to sit beside a building that is still open. That means clean cable routes, covered ramps and no cords across a public walkway.
The Town of Corte Madera handles building and electrical permits. PG&E handles the service request, meter set and any transformer work. We file both as soon as the plans are approved so the utility clock starts early, and we check in with the PG&E planner every week until a date is set. Retail spaces with three-phase gear inside may need a 400A temp service, which takes longer at the utility.
Get a Power Quote
Corte Madera equipment picks
Quiet power for open stores
Tenant work next to open shops needs a low-noise setup. A quiet generator for retail tenant work keeps tools running without drowning out the store next door, and we place it away from entrances.
Cooling for tech rooms
When building HVAC is down during a remodel, cooling for server closets and electrical rooms keeps sensitive gear under its heat limit. Ducted units vent into a ceiling or out a door, and we size them in tons against the heat load of the room.
Eyes on the site after close
Shopping centers empty out at night. Motion-alert cameras for after-hours send clips the moment someone walks onto the site, and the footage is kept for the length of the rental.
Corte Madera pricing
Corte Madera homes on a 100A to 200A temp service usually see $1,800 to $4,500. Tenant spaces using spot coolers pay around $250 to $700 per unit each week, and a small diesel unit costs roughly $500 to $1,200 weekly. PG&E’s own charges arrive on a separate bill.
- Raised mounting on flood-prone parcels
- Night or off-hours install windows
- Generator size and noise rating
- Number of coolers and duct runs
Corte Madera notes for contractors
Shopping center and office landlords often have their own rules for deliveries, staging and fire lanes. Get those rules early. They can change where a generator or cooler can sit, and some centers want proof of insurance before a truck enters the lot.
Low-lying lots can flood in heavy rain. Keep cords off the ground, use GFCI protection on every outlet, and call us before a storm if you want equipment moved. Christmas Tree Hill and the west side are higher and drier, with steeper driveways instead.
Corte Madera FAQs
Can you work around store hours?
Yes. We schedule installs early in the morning or after close when the landlord asks for it. Tell us the center’s quiet hours and we will build the schedule around them.
What if the site floods?
We set gear high and can move it ahead of a storm. Call as soon as you see the forecast.
Do you handle permits with the town?
Yes. We pull the electrical permit with Corte Madera and file with PG&E in the same week. If a tenant space needs a transformer upgrade, we flag it early because it adds lead time.
Rentals and installs in Corte Madera
Power for your Corte Madera job
Call 415-707-8725 and tell us the address, the load and the start date.